About Us - Mikrometer.se

The Backing Plate Is Manufactured Oversized, Since It’s the Part That Wears

The machine only sees the center point of the ball, which is why roundness is everything.

When measurement is built into the machine, even the direction of the digits becomes a design choice

Flip the square, and the error doubles and becomes visible

Hardness isn’t something you can look up — it’s a test result, which means the test must be performed where the part is located

4G Base Station for Loggers — the Measurement Is Worthless if the Alarm Stays on the Site It’s Warning About

90-Degree Right Angle Attachment for the Dial Indicator — When the Measuring Direction Is Correct but There’s No Room for the Instrument

Bore Gauge with Dial Indicator — It Doesn’t Measure the Diameter, It Measures the Deviation, and That’s Why It’s a Hundred Times Faster

Thread Gauges for Thread Measurement — Flank Diameter Determines If a Thread Fits, and It Can’t Be Measured from the Outside

Pin Gauges 1.00–10.00 mm Set — 91 Pins That Can’t Show You Wrong, Because They Don’t Show You Anything

Free shipping over 3000 kr excl. VAT!

Toby Edmundsson

Co-Founder

Jan Broberg

Director, Founder

What are you looking for?

Skicka oss ett e-mail med dina frågor...